Zooming¶

Zoom by 2 points¶

	View toolbar
	Image properties

This function is used to enlarge details of the drawing to fill the screen.
After you activate the function, enter the lower left and upper right corner of a "range" that contains the detail to be enlarged. You can also highlight the upper right corner before the lower left corner.

Last zoom¶

	View toolbar
	Image properties

When this function is selected, the previous zoom area of the active window is displayed.
If you are already working in an image section and require a greater enlargement, simply select a new zoom level to continue working at that level.
To return to your original zoom section, use the LAST ZOOM function.

Fit to screen¶

	View toolbar
	Image properties
	`Ctrl` + `Shift` + `Space`

Selecting this function sets a zoom for all visible elements.
You can run this function periodically to check whether data exists outside of the format (e.g. after importing DXF data).

Zoom with factor¶

	Options toolbar
	Image properties

This function enables the enlargement of an existing depiction around a specified point.
After you activate the function, specify the zoom factor (enlargement factor) and the position of the reference point. The position of the reference point corresponds to individual keys on the numeric keypad. That means that you should enter the number 7 to set the reference point to "upper left". The number 1 stands for "lower left", and so forth.
Finally, you must specify the reference point for the zoom area. This can be performed by clicking the position or entering the coordinates using your keyboard. Pressing Enter without coordinates corresponds with the centre of the page.