Skip to content

Generate Piping Network

Start slope calculation

Icon1 Drainage property bar

This function can be used to create a 3D line in the piping network. (one-line 3D)
The piping network can be edited. (e.g. height modifications)

The load points must be set and the piping must be created before you can carry out the slope calculation.

After you call up the function, click the lower end of the piping network. The intended slope is then requested. The intended slope is removed again by entering "x".

Erklärung

An intended slope in a piping network is not undercut. Modifying the heights of the parts also does not undercut the intended slope. In this case, you are able to set a drop.

Erklärung

If after the slope calculation, a load point is changed with the SET HEIGHT function, the height of the entire piping network is automatically changed so that the intended slope is not undercut anywhere.

Erklärung

If a single point in a piping network is modified using the SET HEIGHT function, which causes the intended slope in the piping to be undercut, an error message (a large X) appears.